請先看『使用說明』

From LEXWiKi

Revision as of 17:48, 5 June 2020

The Sample code source you can download from

=

Source file: F81801_DIO_v0.2_Src_W.zip

Binary file: F81801_DIO_v0.2_x86_Bin_W.zip F81801_DIO_v0.2_x64_Bin_W.zip

How to use this Demo Application

Introduction

F81801 OPEN

BOOL F81801U_Open()
{
	SetPortVal(0x2e, 0x87, 1);
	SetPortVal(0x2e, 0x87, 1);

	if (F81801U_Read(CHIP_ID_REGISTER1) == CHIP_ID_DEFAULT_VALUE1 && F81801U_Read(CHIP_ID_REGISTER2) == CHIP_ID_DEFAULT_VALUE2)
		return TRUE;
	return FALSE;
}

F81801 CLOSE

void F81801U_Close()
{
	SetPortVal(0x2e, 0xaa, 1);
}

Initial internal F81801

void F81801U_Init()
{
	 F81801U_Write(Logic_Device_Number_Register, GPIO_Device_Configuration_Registers);// GPIO Device Configuration Registers (LDN CR06) 
 
	 F81801U_Write(GPIO3_Output_Enable_Register, 0xf0);//GPIO34~GPIO37 OUTPUT SET / GPIO30~GPIO33 INPUT SET
	 F81801U_Write(GPIO3_Drive_Enable_Register, 0xf0);//GPIO34~GPIO37 DRIVE SET
  
	 F81801U_Write(Logic_Device_Number_Register, WDT_Registers);
	 F81801U_Write(WDTDE, 0x01);
	 F81801U_Write(WDT_REG1, 0x40);
	 F81801U_Write(WDOUT_EN, 0x80);
}

F81801U READ

DWORD F81801U_Read(DWORD dwAddrVal)
{
	DWORD dwPortVal;
	::SetPortVal(0x2e, dwAddrVal, 1);
	::GetPortVal(0x2f, &dwPortVal, 1);

	return (dwPortVal & 0x00FF);
}

F81801U WRITE

void F81801U_Write(DWORD dwAddrVal, DWORD dwPortVal)
{
 	::SetPortVal(0x2e, dwAddrVal, 1);
	::SetPortVal(0x2f, dwPortVal, 1);
}

F81801U GetDigitalInput

BYTE F81801U_GetDigitalInput()
{
	CString tmp;
	BYTE byteGPIO3X = 0;
	BYTE byteData = 0;
	byteGPIO3X = F81801U_Read(GPIO3_Pin_Status_Register);
	byteData = byteGPIO3X & 0x0F;

	return byteData;
}

F81801U SetDigitalOutput

void F81801U_SetDigitalOutput(BYTE byteValue)
{
	BYTE byteData = 0;

	byteData = (byteValue & 0x01) ? byteData + 0x10 : byteData;
	byteData = (byteValue & 0x02) ? byteData + 0x20 : byteData;
	byteData = (byteValue & 0x04) ? byteData + 0x40 : byteData;
	byteData = (byteValue & 0x08) ? byteData + 0x80 : byteData;

	F81801U_Write(GPIO3_Output_Data_Register, byteData);
}