MB:SI852A

Pls follow the fews steps to open your video-in devices!!

1.Make sure your video-in devices all supported by bttv driver
Use the command

• $dmesg |grep bttv
  you should be saw the message as red block !!
  
  

2.Make sure the Video-in modules have ready to supported
use the command

• $lsmod
  you should be saw the message as red block!!
  
  

3.Got the test utility "xawtv" by Apt !!
As command

• $sudo apt-get install xawtv
  the some dependences module also will be download,like "libzvbi-common" / "libzvbi0" / "pia" /"v4l-conf" .
  
  

4.Open your Video-in devices by xawtv
if you want to open Video 1,Pls use the command

• $xawtv -c /dev/video0
  

$sudo apt-get install xawtv

N/A

Taipei / Leon.Hsu 2008/7/9

Leon 2008/7/10

We use the bttv devices driver and Xawtv project to test!!

1.Got the Xawtv

• $sudo apt-get install xawtv // for Ubuntu user
  
• $yum install xawtv //for Fedora user
  

2.Turn on your Video-in Devices

• $xawtv -c /dev/video0 // example for your channel 1 ,The channel 2 will be /dev/video1
  

3.Adjust your Video-in Devices
As red block ,here you can setting your Video format like NTSC or PAL

• $sudo apt-get install xawtv
  
• $yum install xawtv
  

N/A

Robert 2008 / 7 / 14

Leon 2008 / 7 / 14

1. using the tool " xawtv "
2. press right button on display frame to setting option
3. switch video source: ( check attached file )

  Television  as channel 1
  Composite1  as channel 2
  S-Video     as channel 3
  Composite3  as channel 4

• apt-get install xawtv

N/A

Robert 2008/11/28

Denny 2008/12/02

In CentOS 5.0, you can get board temperature in dmesg.

#dmesg | grep Thermal

About board voltage,use lm-sensors to find.

#yum install lm_sensors.i386 lm_sensors-dev.i386
#sensors-detect
#sensors

N/A

N/A

Patty 09:56, 23 February 2009 (CST)"writ Asker & date"

Patty 09:56, 23 February 2009 (CST)"writ Provider & date"

You will got asynchronous image when you load Bttv driver for BT878 capture function,
It was Bttv driver bug cause of the error image
Because Bttv driver can't auto-switch the BT878 register when you change to PAL model

Thereby We should configure bttv driver correct parameter,Please follow the below procedure to done!!

• Remove the Bttv driver
  

#rmmod bttv 
 

• Reload the Bttv driver and provide the correct parameter for PAL
  

#modprobe bttv pll=1,1,1,1

• Run your capture application ,for example we used the xawtv

#xawtv

• Select the PAL model
  

N/A

N/A

Robert 09/04/29

Leon 09/04/29